Morrisville UDO Administrative Manual - July 2016

Part 4 Appendices 4.5 Checklists

New Telecommunication Facility Construction Plan Approval for a Site Plan (Major or Minor) Submittal Checklist For each listed item, check (√) if provided, write “n/a” if the feature does not exist or is not proposed, and write “w” if a waiver from the requirement is justified because it is unnecessary in the particular case to determine compliance with applicable regulations. Staff Use Only √, n/a, or w Application Submittal Requirement √, n/a, or w Proposed use(s) (see Section 4.2.4, Principal Use Table, UDO) Proposed building square footage (if applicable)

Number of parking spaces required and proposed as well as the supporting calculation Lot Coverage percentage including a breakdown for sidewalks, building(s), parking, drive aisles, and other non-pervious materials

7 Location and dimensions of the facility (facility footprint)

8 Location and dimensions of existing and proposed driveways and curb cuts on site to be developed and on adjacent properties within 500 feet of the project site 9 Location, material, and width of existing and proposed sidewalk(s), greenway(s), and crosswalk(s) on the site to be developed and on adjacent properties. 10 Location and width of existing and proposed public/private greenway(s) and access easement(s) 11 Location and width of existing and proposed rights-of-way and road widths, including road names and State Road (SR) number

12 Location, width, and type of each perimeter buffer 13 Location, width, and type of each streetyard buffer 14 Location and width of minimum setbacks 15 Location and width of landscape buffer around compound area

16 Location and dimensions of proposed hotboxes, HVAC units, and other on ground/free standing mechanical equipment 17 Width and depth of parking bays 18 Width of drive aisle 19 Turning radius at entrances and traffic islands 20 Location, width, and type of each riparian buffer encroaching within the site measured from the top of the stream bank 21 Location and width of fire lane (if applicable) 22 Length of fire access roadway(s) with any required turnarounds 23 An “*” on each lot indicating that the lot, or a portion of the lot, is located within a designated FEMA floodplain with a corresponding note that referencing Section 5.6, Floodplain Management, of the UDO and the corresponding requirements 24 Wastewater System 25 Show existing and proposed easements for all sewer lines, indicate status of easement acquisition across any off-site properties. Verify easement width for proposed depth. 26 Label all manholes that are greater than 4’ in diameter. 27 Water System 28 Show existing public waterlines and appurtenances, show existing and proposed easements for all proposed water lines, indicate status of easement acquisition across any off-site properties 29 Show existing and proposed hydrants F Grading and Drainage Plan (if applicable) 1 An overall drainage and grading plan shall be provided showing existing and proposed contours. 1% minimum slope impervious areas, 2% minimum slope pervious areas. 2 Stormwater Layout Design Location and dimensions of pipes, culverts, and other storm drain system elements Stormwater Table- drainage structure ID, rim/grate, pipe diameter, material, slope, inlet and outlet inverts, structure type, drainage area and flow into the pipe structure Public drainage easements for all pipes collecting water from public right-of-ways Any extensions of storm drain outfalls across adjoining property and any private drainage easements needed to ensure discharge into natural watercourse Each BMP shall be on an individual plan sheet with associated BMP specific plan & profile/section views, and all applicable construction details Include a table of pertinent design parameters with columns indicating Existing/Required, Design/Provided, and As-Built columns including, but not limited to: Drainage Area (sf) 3 Stormwater Quality/Quantity Best Management Practices (BMPs)

July 1, 2016 Page 4-80

Morrisville, NC

Administrative Manual