Morrisville UDO Administrative Manual - July 2016

Part 4 Appendices 4.5 Checklists

Preliminary Subdivision Plat Approval (Type 1 or Type 2)

Preliminary Subdivision Plat Approval (Type 1 or Type 2) Submittal Checklist For each listed item, check (√) if provided, write “n/a” if the feature does not exist or is not proposed, and write “w” if a waiver from the requirement is justified because it is unnecessary in the particular case to determine compliance with applicable regulations. Staff Use Only √, n/a, or w Application Submittal Requirement √, n/a, or w A Documents to be Submitted 1 This completed checklist 2 Application 3 Application fee schedule and fee payment 4 Sets of plans – stapled, collated, and folded (8 copies)

5 Board no larger than 18 in. x 24 in. showing proposed exterior materials and primary and accent colors 6 Elevation and bench marks referenced to National Geodetic Vertical Datum (NGVD) 7 Compact disc of plans with a PDF of each submitted plan sheet and all reports/documents 8 Transportation Impact Analysis or reduced set of analysis requirements (must comply with MOU) 9 Copy of notification letter sent to Raleigh-Durham Airport Authority 10 Copy of all stream determinations & signed JDs (jurisdictional determinations) 11 Bound stormwater report 1 Name, address, telephone number, of Engineer, Architect, or Landscape Architect licensed in the State of North Carolina responsible for the plans 2 Date of drawing preparation and all revision dates 3 Sheet number and title 4 North arrow (except detail and elevation sheets) 5 The scale of the drawings listed in feet per inch in both graphic and numeric scale. Engineering scale no smaller than 1” = 25’ and larger than 1” = 100’ is recommended (except detail & elevation sheets) 6 Seal of Registered Design Professional registered in the State of North Carolina (signed and marked as preliminary) 7 Name of the proposed development in title block 8 Project number in lower right hand corner (number assigned once project submitted) C Cover Sheet Information 1 Name of proposed development and “Construction Plan” 2 Vicinity map at 1” = 400’ with project boundary clearly marked. There must be sufficient detail and legibility to locate the project in reference to nearby roads. 3 The dates, resolution or ordinance number(s), and details of any previously approved rezoning, design, or sign guidelines for the project site 4 All general notes 5 Sheet Index (Note: The plan must be in the same order as this checklist) D Existing Conditions Survey 1 Property lines clearly presented showing all bearings and distances, with an accuracy of closure in accordance with the Standards of Practice in NC GS 4730 from a current survey. Sufficient data must be included to reproduce on the ground every straight or curved boundary line, lot line, right-of-way line, and easement. Survey must be signed and sealed by a North Carolina Licensed Professional Land Surveyor. 12 Voluntary Annexation Petition, if required 13 Road name approval from Wake County B Base Information for Each Plan Sheet

2 Names of adjoining property owners and subdivisions 3 Adjoining zoning districts – boundaries and names

4 Jurisdictional boundaries 5 Adjoining current land uses 6 Right(s)-of-way or easement(s) e.g. street, railroad, and utility 7 Street name, right-of-way width, public or private, and state road number 8 Water, sewer, natural gas, and other utility lines 9 Existing structures (buildings, fencing, etc.) 10 Topographic contours (cite source)

July 1, 2016 Page 4-36

Morrisville, NC

Administrative Manual